FAQ – Samsung Galaxy Gear S3 SmartWatch

1. Gear S3 flashes red, the watch does not respond, and the screen does not turn on.
Cause: Usually the hardware is damaged.

2. The charging head is hot and will consume power immediately
Cause: There is usually a problem with the system version. You might consider downgrading the system version. The recommended version is QH1.

3. The watch has penetrated into the water and the bezel has broken.
Solution: Turn off the power immediately. Do not use a hair dryer to blow dry or disassemble the watch to dry it.

4. Since the watch has not been used for some time, it cannot be charged after turning off the power. This screen does not appear while charging.
Cause: The charging IC may have entered a protection state. The battery may be over discharged.

5. How does s3 change my original Samsung ID?
Connect the phone. The phone has Gear software to release the ID.

6. What type of drive is used to remove the S3 watch?
Y screwdriver

7. One of the keys on the watch is broken and cannot be used.
Solution: Replace the button cable

8. There is a problem with the power button on the watch. After the connection is complete, the power cannot be turned on and the battery is fully charged. However, the clock does not turn on after pressing the power button. You can reopen it later. what is the reason
The power IC is shorted, the battery is damaged or even the system version.

9. Watermark spots appear on watch screen
Cause: Clock screen is squeezed

10. Monitoring sensor failure
Solution: Downgrade system version or replace motherboard

11. The watch cannot be charged
Cause: Degraded battery or short circuit on motherboard IC

12. The watch keeps restarting
Cause: The system file is damaged or the hardware is faulty.

13. What is the diameter of the waterproof seal on the back cover?
Approximately 30 in diameter

14. Can the watch’s back cover be repaired?
Yes, you can change the watch case.

15. All the sensors on the watch suddenly broke down, raised my hand, and could no longer calculate my heart rate and steps. Reset, clear, downgrade and upgrade are all invalid. “FAIL” is displayed on the watch self-test sensor, and the data is 0.
Cause: The hardware is damaged.

16. The watch was soaked in sea water
Solution: We recommend that you send to a repair shop.

17. Less than half a day after the watch is fully charged, is the remaining power less than 40? You cannot hear songs without Bluetooth.
Criterion for measuring whether the battery is normally lost: For full-link phones, the screen is always on. If it can be maintained for more than 24 hours, there is no need to replace the battery. Conversely, if the battery leaks severely, you need to replace it with a new one.